Speedtech B Body Rear Trailing Arm Manual do Utilizador descarregar pdf (Página 6)

6 | P a g e

Sway Bar Installation

1. Use the sway bar hardware to attach bar to the rear axle. Do not fully tighten

at this time. See sway bar instructions for further information.

2. You will not be using the end links and associated hardware that come with

the sway bar. Bolt the end links that come with the trailing arms to the sway bar

on the inside of the bar, with the spacer between the link and the sway bar. Do

not fully tighten yet. Attach the upper link brackets to the links and position with

the vertical tab against the front of the frame cross member. Be sure the links are

standing vertically. Mark three holes to bolt down each of the brackets. Remove

the bracket from the links and drill the holes with the 5/16”” bit. Bolt down the

brackets with the 5/16” bolts, nuts and washers, then bolt the links to the

brackets using the 3/8” bolts.

1 2 3 4 5 6 7 8

Sem comentários

Speedtech B Body Rear Trailing Arm Manual do Utilizador Página 6